Hole Cutting Machine Safe Operation Regulations

Hole Cutting Machine and hydraulic working pump station need to use bending machine to complete the production and deformation correction process of specific parts during production. Therefore, the process of Hole Cutting Machine production strictly follows the following procedures:

1. Strictly abide by the Hole Cutting Machine's safe operation rules and wear labor protection equipment according to industry and enterprise regulations.

2. Before starting, you must carefully check whether the motor, switch, circuit and grounding are normal and firm, and check that all operating parts and buttons of the Hole Cutting Machine such as the bending machine are in the correct position.

3. Check the overlap and firmness of the upper and lower molds; check whether the positioning devices meet the processing requirements of Hole Cutting Machine.

4. When the upper slide plate and each positioning axis are not at the origin, the reset function is started when the machine is turned on to make the Hole Cutting Machine run to the origin program.

5. After the Hole Cutting Machine is started, it runs idling for 1-2 minutes, and the skateboard moves 2-3 times at full stroke. If you find abnormal sounds or malfunctions, you should stop immediately, remove the fault, and wait for the Hole Cutting Machine to work normally. .

6. When working, one person should give unified command, so that the operator and the feeding and suppressing personnel can cooperate closely to ensure that the cooperating personnel are in a safe position before the bending signal is issued.

7. When bending the sheet, it must be compacted to prevent personal injury due to the bending of the sheet during the bending. When personnel produce Hole Cutting Machine parts on the bending machine, in addition to the necessary protective clothing, an additional baffle should be added to ensure safety .

8. The power supply must be cut off when adjusting the sheet metal die, and the operation should be stopped.

9. When changing the opening of the variable lower mold, no material is allowed to contact the lower mold.

10. When the Hole Cutting Machine is working, no people are allowed to stand behind the Hole Cutting Machine.

11. It is strictly forbidden to fold the sheet at one end alone.

12. If the workpiece or mold is found to be incorrect during operation, stop and correct it. It is strictly forbidden to correct it by hand to prevent hand injury.

13. It is forbidden to fold over-thick iron plates or quenched steel plates, high-grade alloy steels, square steels, and sheets that exceed the performance of the sheet metal bending machine to avoid damage to the Hole Cutting Machine.

14. Frequently check the overlap of the upper and lower molds; whether the instructions of the pressure gauge meet the regulations.

15. In case of an abnormality, stop immediately, check the cause and eliminate it in time.

16. Before shutting down, place wooden blocks on the lower molds under the cylinders on both sides to lower the upper slide onto the wooden blocks.

17. Exit the Hole Cutting Machine control system program first, and then cut off the power.