HYDRAULIC ELECTRIC STEEL PIPE CUTTER (TWQ-VIA)
The model TWQ-VIA hydraulic electric steel pipe cutter is portable. It design for the limit screw to accurately position the blade. And the relief handle help to quick reposition the blade after cutting. It can effectively save working time. If need to cut the stainless steel and carbon steel pipe, you can choose our another model TWQ-VIIA cutter.
PRODUCT INTRODUCTION
● This machine is designed for cutting 3/8"-2" steel pipe, very high efficiency which can cut off a steel pipe within a few seconds.
● The knurl roller is designed with a saw - blade to remove the burrs of pipe ends.
SPECIFICATIONS
● Capacity: 3/8"-2" (Φ 16-Φ 60) SCH40 steel pipe.
● Max. wall thickness: 4mm.
● Output RPM: 105rpm.
● G. W: 55kgs.
● Packaging size: 33x37x66(cm).
Standard Equipment | |||
*For SCH40 steel pipe | |||
Art. No. | Description | N.W(kgs) | Ref No. |
03.02.01.020 | Alloy blade | 0.22 | (1) |
Motor Parameter | ||
Phase | Voltage | Frequency |
Single Phase | 110 / 120 / 220 / 230 / 240V | 50/60 Hz |
Three Phase | 220 /380 / 415 / 440V | 50/60 Hz |
PRODUCT DETAILS
During the operation, you may vary the position of limit screw depending on the diameter of pipe so as to obtain the preferred position of stroke of link rack and blade, resulting in higher cutting performance.
After the pipe has been cut off, hold down the relief handle to let the cutting blade returns to its original high position together with the link rack.
TROUBLESHOOTING
Problem | Causes | Solutions |
No pressure in the oil cylinder. No action resulted from turning the handle. | 1.Insufficient hydraulic oil. | Add hydraulic oil. |
2.Dirt oil blocks the suction hole. | Replace the hydraulic oil, clean the strainer. | |
3.Leakage occurs to the fitting surface of inlet valve. | Remove the screws and spring. Knock the small steel balls lightly to force out the air-tight surface. | |
4.Spindle of relief value has been blocked. | Replace the hydraulic oil. | |
The piston will move forward when the handle is forced downward, but it will return when the handle is released. | 1.Dirt oil blocks the hole. | Replace the hydraulic oil. |
2.Leakage occurs to the fitting surface of outlet check valve. | Remove the screws and spring. Knock the small steel balls lightly to force out the air-tight surface. | |
3.Leakage occurs to other position. | Trace the problem and reinstall. | |
Significant burrs or edge curls are found at the ends of steel tube in the process of cutting. | 1.The saw blade is not in the middle of roller. | Loosen nut on the roller spindle and limit screw. Turn the saw blade slightly for less than 10 degrees to move the worn-out or damaged cutting edge out of cutting scope. Keep turning screw till it touches the saw blade followed by tightening screw. |
OUR SERVICE
1. We have established worldwide network to guarantee our timely response for your any demand no matter where are you.
2. We welcome engineers from your side to learn the technical design and normal maintenance here, this will help your easy in understanding and helpful if you need to be our dealer.
3. However, don't worry, we have our company own CD/Manual to show you along with the machine. So you can learn this from the existing documents to deepen your knowledge and understanding.
4. Anyhow there are another way is through internet video face to face for machine teaching, because of the high development in internet, the world has become smaller and you can easy contact us if any assistance needed.
5. Through all the ways, we will guarantee the service quality and ensure you will be well helped anytime anywhere.