Introduction Of Pipe Roll Grooving Machine

Put the main body of the Pipe Roll Grooving Machine on the rail that needs to be drilled. After adjusting the position of the hole according to the hole distance of the rail connecting plate and the ruler on the main body of the Pipe Roll Grooving Machine, screw the hexagonal screw sleeve under the ruler to the rail. Position the holed female mold tightly. Tighten the stop valve of the hand pump, loosen the vent plug on the hand oil tank, and press the handle of the hand pump. When you hear the crisp sound of cutting holes, the holes have been opened. At this time, loosen the stop valve of the hand pump, and the piston rod of the oil cylinder drives the male mold to return to its original position. At the same time, the hexagon screw sleeve under the ruler is reversely loosened to keep the female mold away from the rail. When you need the Pipe Roll Grooving Machine to open the second hole, just measure the center distance between the hole and the hole, and continue according to the first hole operation procedure.

1. Before the Pipe Roll Grooving Machine drills the hole, drill a 11.5mm guide hole with a hand drill.

2. Screw the piston rod of the Pipe Roll Grooving Machine into the screw hole of the piston cylinder, and then insert the washer into the piston rod and then into the die. Then extend the piston rod of the Pipe Roll Grooving Machine into the guide hole of the workpiece, and finally screw into the punch to make the knife edge of the punch and the processing surface tightly integrated, and the punch, workpiece and concave mold are reliably fixed.

3. Close the oil return valve in a clockwise direction, and then repeatedly press the afterburner handle to make the piston pump work.