Hole Cutting Machine Operating Specifications

Hole Cutting Machine is a safe, environmentally friendly, economical and efficient in-service pipeline maintenance technology. It is suitable for the normal maintenance and transformation of crude oil, refined oil, chemical media, natural gas and other media pipelines and emergency repairs (such as Pressure emergency repair, replacement of corroded pipe sections, installation of equipment, distribution and transformation, etc.). Today, the editor will tell you about the operating specifications of Hole Cutting Machine.

1. Plug the Hole Cutting Machine into the power source, turn on the motor switch, check the operation of the equipment, and turn it off after confirming that it is running normally.

2. Attach the V-shaped iron on the base of the Hole Cutting Machine to the pipe, then adjust the length of the chain and position it with a pin, and then tighten the nut at the other end of the chain to make the machine firmly positioned on the pipe.

3. Confirm the diameter of the Hole Cutting Machine according to the regulations, and set the appropriate Hole Cutting Machine.

4. Start the motor and reconfirm the Hole Cutting Machine, the Hole Cutting Machine is operating normally.

5. Pull (press) the handle of the Hole Cutting Machine to make the Hole Cutting Machine downward slowly. When approaching the tube, check whether the Hole Cutting Machine position is correct; otherwise, turn off the machine and re-adjust the position before turning it on again.

6. In Hole Cutting Machine, the handle should be pressed down slowly, and the Hole Cutting Machine should be cooled with coolant continuously.

7. After Hole Cutting Machine is finished, turn off the motor and unload the machine. Handle Hole Cutting Machine carefully. What are the operating specifications of Hole Cutting Machine. Do not consign the machine on the ground.