Operation Method Of Pipe Roll Grooving Machine

Pipe Roll Grooving Machine tapping technology is mainly used in pipelines without stopping the conveying medium and without reducing the pressure. It has a certain degree of danger. It is also possible to use the pressure-to-empty method to open the bypass and change the valve of the pipeline. To use a professional Pipe Roll Grooving Machine to operate, the specific method is:

1. Plug the Pipe Roll Grooving Machine into the power source, turn on the motor switch, check the operation of the equipment, and turn it off after confirming that it is running normally.

2. Attach the V-shaped iron on the base of the Pipe Roll Grooving Machine to the pipe, then adjust the length of the chain and position it with a pin, and then tighten the nut at the other end of the chain to firmly position the machine on the pipe.

3. Confirm the diameter of the tapping hole under pressure according to the regulations, and install a suitable tapping hole device.

4. Start the motor, reconfirm the Pipe Roll Grooving Machine, the press hole opener is operating normally.

5. Pull (press down) the handle of the Pipe Roll Grooving Machine to slowly lower the pressure hole opener. When approaching the pipe, check whether the pressure hole position is correct; otherwise, turn it off and re-adjust the position before turning it on again.

6. When opening the hole under pressure, the handle should be pressed down slowly, and the pressure hole opener should be continuously cooled with coolant.

7. After opening the hole under pressure, turn off the motor and remove the machine. Handle with care and do not consign the machine on the ground. Pipe Roll Grooving Machine